Terasic Products

USB Blaster Description
USB Blaster Download Cable

  • Compatible with Altera USB Blaster
  • Supported JTAG Voltage: 2.5V ~ 3.3V
  • Better anti-noise capabilities
  • The same circuit is used in Altera DE2 Board designed/manufactured by Terasic
Stratix 10 Beschreibung
DE10-Pro

  • Intel Stratix 10 GX/SX FPGA
  • Four QSFP28 connectors and one PCI Express (PCIe) x16 edge connector
  • Four independent DDR4 SODIMM sockets (work with DDR4/QDR-II+/QDR-IV)
Stratix V Description
TR5 FPGA Development Kit

  • Stratix V GX 5SGXEA7N2F45C2N
  • DDR3 SO-DIMM and FMC x4 Connectors
  • Large ASIC Prototyping Applications
TR5-F40W

  • Altera Stratix® V GX FPGA (5SGXEA3K2F40C3)
  • On-Board USB Blaster II or JTAG header for FPGA programming
  • Fast passive parallel (FPPx32) configuration via MAX II CPLD and flash memory
  • SSRAM, FLASH
TR5-Lite

  • Altera Stratix® V GX FPGA (5SGXEA7N2F45C2)
  • Two SFP+ connectors, One Serial ATA (SATA II) host port
  • DDR3 SDRAM, QDRII+ SRAM, FLASH
Terasic DE5-NET Development Kit

  • Altera Stratix® V GX FPGA (5SGXEA7N2F45C2)
  • 32MB SRAM (ISSI QUADP for DE5-Net 450, GSI SigmaQuad-II+ for DE5-Net 550, Cypress QDRII+ for DE5-Net 500)
  • Up to 8GB DDR3 800 MHz SO-DIMM SDRAM
Stratix V GX Video Development System

  • Stratix V GX FPGA 5SGXEA7K2F40C2N
  • DDR3 SDRAM, QDR II+ SRAM, RLDRAM II
  • PCIe x8, HSMC, SDI, QSFP, Gigabit Ethernet, DVI I/O
Stratix IV Description
Terasic TR4 FPGA Development Kit

  • Stratix IV GX EP4SGX230/EP4SGX530 with High Speed Transceivers
  • 2x PCIe x4 Connectors and DDR3 SO-DIMM Slot
  • Stackable Design for Multi-FPGA System
Altera DE4 Development and Education Board

  • Stratix IV GX EP4SGX230/EP4SGX530 with transceivers
  • PCIe x8 Connector and 2 DDR2 SO-DIMM
  • High-Performance and Bandwidth Applications
Stratix III Description
Altera DE3 Development System

  • Stratix III EP3SL150 F1152
  • DDR2 SO-DIMM and USB Device/Host
  • Large ASIC Prototyping Applications
Arria 10 Description
TR10a-LP QDRII+ Arria 10 FPGA Development Kit

  • Intel Arria 10 GX FPGA (10AX115N3F45E1)
  • Low Profile PCIe Gen3 x16 (Dual PCIe Gen3 x8) Board
  • Two QSFP+ Connectors
  • Five Independent 550MHz QDRII+ SRAMs
TR10a-HL2 Arria 10 FPGA Development Kit

  • Arria 10 GX FPGA (10AX115N3F45E1)
  • Half-length PCIe Gen3 x8 board
  • Four QSFP+ connectors
  • Six independent 550MHz QDRII+ SRAMs
DE5a-Net-DDR4 Arria 10 FPGA Development Kit

  • Altera Arria 10 GX FPGA (10AX115N2F45E1SG)
  • Four QSFP+ connectors and one PCI Express (PCIe) x8 edge connector
  • Two independent DDR4 SODIMM socket and four independent 550MHz QDRII+ SRAMs
DE5a-Net Arria 10 FPGA Development Kit

  • Altera Arria 10 GX FPGA (10AX115N2F45E1SG)
  • Four QSFP+ connectors and one PCI Express (PCIe) x8 edge connector
  • Two independent DDR3 SODIMM socket and four independent 550MHz QDRII+ SRAMs
Arria V Description
Arria V GX Video Development System

  • Arria V GX 5AGXFB3H4F35C5NES
  • DDR3 SDRAM, SSRAM
  • HDMI 1.3 TX, SDI 3G, Ethernet, DVI I/O
Arria II GX Description
Arria II GX-260 FPGA Development Board

  • 256,000 logic elements (LEs)
  • 102,600 adaptive logic modules (ALMs)
  • 11,756 Kb on-chip memory
Arria II GX Video Development Board

  • Arria II GX EP2AGX125 with transceivers
  • 128MB DDR3 device, DDR2 SO-DIMM, 2MB SSRAM, 64MB FLASH
  • Gigabit Ethernet, PCIe x8 Connector
Cyclone V Description
DE0-Nano-SoC Kit/Atlas-SoC Kit

  • Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
  • 1GB DDR3 SDRAM (32-bit data bus, HPS)
  • Arduino Expansion Header (Uno R3 Compatibility), UART-to-USB, USB OTG Port, Micro SD Card Socket, Gigabit Ethernet and GPIO Headers
VEEK-MT-SoCKit

  • Equipped with an 7-inch amorphous-TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
  • Module composed of LED backlight
  • Supports 24-bit parallel RGB interface
  • Converting the X/Y touch coordinates to corresponding digital data via Touch controller
DE0-CV Board

  • Cyclone V 5CEBA4F23C7N Device
  • 4-bit Resistor VGA
  • Provides SPI and 4-bit SD mode for SD Card access
  • Serial Configuration device – EPCS64
  • 64MB SDRAM, x16 bits data bus
  • On-Board USB Blaster (Normal type B USB)
DE1-SoC Board

  • Cyclone V SoC with Dual-core ARM Cortex-A9 (HPS)
  • 1GB DDR3 and 64MB SDRAM
  • VGA Out, Video-In, UART-to-USB, USB Host x2, Micro SD Card Socket, 1Gbps Ethernet, and GPIO Headers
SoCKit – the Development Kit for New SoC Devices

  • Cyclone V SX SoC with Dual-core ARM Cortex-A9 (HPS)
  • 2GB DDR3, 128MB QSPI Flash, EPCQ256
  • SD-card, USB OTG, LCD, Ethernet, UART to USB, Transceiver, HSMC
Cyclone V GX Starter Kit

  • Cyclone V GX 5CGXFC5C6F27C7N Device
  • LPDDR2, SRAM, FLASH EPCQ256
  • Arduino Header, 2×20 GPIO Header, HSMC, UART to USB, HSMC, HDMI TX
VEEK-MT-C5SoC

  • Cyclone V SX SoC 5CSXFC6D6F31C8N~110K LEs
  • 5-Megapixel Digital Image Sensor Module
  • 7″ LCD Touch Screen Module
Cyclone V E Video Development System

  • Cyclone V E FPGA – 5CEFA7F31C7NES
  • DDR3, LPDDR2, Flash, SSRAM, EEPROM
  • Ethernet, UART interface, HSMC, DVI I/O
Cyclone V GX Video Development System

  • Cyclone V GX FPGA 5CGXFC7D6F31C7NES
  • DDR3 SDRAM, Flash
  • USB, Gigabit Ethernet, PCIe x4, HSMC, SDI, DVI I/O
Cyclone IV Description
DE2i-150 FPGA Development Kit

  • Cyclone IV GXP4CGX150F31 device
  • Intel® Atom™ Dual Core Processor N2600( 1M Cache, 1.6GHz )
  • Supports Windows & Linux Operation Systems
Altera DE2-115 Development and Education Board

  • Cyclone IV EP4CE115 with ~114,480 LEs
  • 2 Gigabit Ethernet Ports, HSMC connector
  • 128MB SDRAM, 2MB SRAM, 8MB Flash
DE0-Nano Development and Education Board

  • Ideal for use with embedded soft processors
  • Tiny and robust packaging for portable applications
  • Expansion headers for daughter cards, motors, actuators, etc.
Video and Embedded Evaluation Kit – Multi Touch

  • Cyclone IV EP4CE115 with ~114,480 LEs
  • 5-Megapixel Digital Image Sensor Module
  • 7″ LCD Touch Screen Module
Industrial Networking Kit (INK)

  • Cyclone IV EP4CE115 with ~114,480 LEs
  • 2 Gigabit Ethernet Ports, HSMC connector
  • Supports CAN, RS-485, and RS-232 interfaces
Cyclone III Description
Cyclone III Video Development System

  • Cyclone III EP3C120F780 with ~120,000 LEs
  • 256MB DDR2 SDRAM, 8 MB SSRAM, and 64MB Flash
  • Gigabit Ethernet and Graphic LCD
MAX 10 Description
DE10-Lite Board

  • MAX 10 10M50DAF484C7G Device
  • Accelerometer and 4-bit Resistor VGA
  • 64MB SDRAM, x16 bits data bus
  • Arduino UNO R3 and 2×20 GPIO connector
  • On-Board USB Blaster (Normal type B USB)
MAX 10 NEEK

  • MAX 10 10M50DAF484C6G with 50k LEs
  • DDR3 with ECC, QSPI Flash, MicroSD Card
  • Ethernet, Audio codec, HDMI RX, Acceleromter, ADC, DAC
  • 8-Mega pixel color camera and 7″ 5-point touch screen
Accessories Description
Please see the Terasic website (www.terasic.com) for information on accessories that can be ordered through us.

  • Multimedia Daughter Cards
  • Interface Conversion
  • Video & Image
  • Networking
  • AD/DA Converter
  • Adapter
  • Cables
  • Extras